CONTACT INFO:
Unit J 2 Torrens Road
East tamaki
Auckland
New Zealand
Phone: (09) 271 2493
Fax: (09) 271 5327
Email:
info@trilect.co.nz
Untitled document
Skipper
Low-voltage, electro-mechanical operator with articulated arm for swing gates. Residential use.
Complies with the current safety standards as regard to obstacle detection and inversion of movement in accordance with EN 12453 and EN12445.
Built-in control unit with self-learning programming and possibility of adjusting the parameters by means of a simple and intuitive menu.
Articulated arm fitted with mechanical limit switch to adjust the stroke and prevent the positioning in negative angle. The operators are equipped with mechanical limit-switches to adjust the stroke.
Emergency release positioned on the side of the operator. It can be remotized to allow the release from the outside.
Emergency power supply, in the event of power failure, guaranteed by two optional emergency batteries.
TECHNICAL DATA
POWER SUPPLY
230 Vac - 50/60 Hz
MOTOR POWER SUPPLY
24 V
ABSORBED POWER
70 W max. each motor
ABSORBED CURRENT
4 A max. each motor
MAX. THRUST TORQUE
150 Nm
OPERATING TEMPERATURE
-20ºC to +70ºC
MAX. LEAF LENGTH
2,3 m (without electric lock) 3,0 m (with electric lock)
IRREVERSIBLE
Yes
NUMBER OF DAILY CYCLES
80 max.
MAX. LEAF OPENING ANGLE
120°
PROTECTION CLASS
IP 44
OPERATOR DIMENSIONS OPERATOR POSITIONING
DESCRIPTION
Max. leaf width
CODE
SKIPPER Electromechanical operator with articulated arm and built-in control unit and radio receiver
2,3 m (without electrick lock)* 3,0 m (with electrick lock)
41022/001
SKIPPER SLAVE Electromechanical operator with articulated arm
2,3 m (without electrick lock)* 3,0 m (with electrick lock)
41022/002
* For leaf longer than 2,3 meters is recommended the use of an electric lock.
DESCRIPTION OF OPTIONAL ACCESSORIES
CODE
Long Lever (ideal for large pillars)
41022/050
TR2 - 433.92 MHz twin-channel transmitter
41903/002
ER4N - Pair of photocells
41812/001
PC12E - Key switch for wall mounting
41830/007
CAL - Aluminium column for the ER4N photocells
41812/050
433,92 MHz antenna
41929/001
ES3 - Electric lock complete with ground striker plate (for gate leaf longer than 1,8 m up to 3 m) CL series cylinder required
41080/008
CL1 - “DEAD HEAD” single cylinder
41080/005
CL2 - “DEAD HEAD” double cylinder
41080/004
CS - External strongbox
41704/002
CSP - Wall - mounted external strongbox
41704/003
Back up battery
41702/003
IDEAL INSTALLATION
Qty
CODE
Electromechanical operator with articulated arm and built-in control unit
1
41022/001
Electromechanical operator with articulated arm
1
41022/002
ER4N - Pair of photocells
1
41812/001
PC12E - Key switch for wall mounting
1
41830/007
One TR2 - 433,92 MHz twin-channel transmitter
1
41903/003
ET2N - 24 V flashing light
1
41840/006
NOTE: for control and safety devices and installation accessories, see section “Electronic devices and installation accessories” in this catalogue (consult the index).
